METHOD OF STATEMENT FOR ELECTRICAL WIRING FOR LIGHTING & POWER POINTS

Introduction And Scope 

This method of statement specifies the detailed requirements and procedures for the MEP installation (Electrical Wiring For Lighting & Power Points) of the above-mentioned project.

Methodology-for Electrical Wiring For Lighting & Power Points:

1. Ensure all the related documents like currently approved shop drawings and load schedules are available with the installation team.
2. Transfer the required number of wires from stores to the workplace.
3. Before pulling wires, check and ensure there are no sharp edges or burrs to prevent damage while pulling wires.
4. Identify the correct size and color. (Following the assigned/specified color coding) of wire, cut to the required length appropriately.
5. Do not bunch two circuits together, if done so, for easy installation. shall be removed after installation.
6. Pull the wires through conduits with the help of pull wires.
7. Ensure no joints are made in any circuit.
8. Leave a minimum of 250 millimeters in length or more according to the requirement which should be enough to connect to the desired terminals.
9. Cover Conduit junction boxes with appropriate covers.

To download the complete method statement file, click on the download link given below:

 METHOD OF STATEMENT FOR ELECTRICAL WIRING FOR LIGHTING & POWER POINTS 

👇

 METHOD OF STATEMENT FOR ELECTRICAL WIRING FOR LIGHTING & POWER POINTS